1) Remove Front Grille of speaker.

2) Remove screws from the speaker(s) in need of service.

3) Some speakers may have putty sealant behind it.
If the speaker does not remove by hand, a flat head
screwdriver may be used to lightly pry - by inserting it underneath
the frame of the speaker.

4) Once the speaker is removed, you will notice two color coded
wires. One wire is positive (red dot, plus, or X mark), the other
negative. Unsolder the wires from the terminals.

Customers who do not have knowledge of soldering can cut the wires a few inches
above the speaker terminals.

When re-installing the speaker, the end of the wires can be stripped, twisted together
and capped with an electrical nut. This is the only alternative to a decent
connection.
Note: Always connect the same color wires together - positive to positive / negative to negative.